Omega CNI16 Bedienungsanleitung PDF herunterladen (Seite 18)

PART 3

OPERATION: Configuration Mode

3.1 Introduction

The instrument has two different modes of operation. The first, Run Mode, is

used to display values for the Process Variable, and to display or clear Peak

and Valley values. The other mode, Menu Configuration Mode, is used to

navigate through the menu options and configure the controller. Part 3 of this

manual will explain the Menu Configuration Mode. For your instrument to

operate properly, the user must first "program" or configure the menu options.

Turning your Controller On for the First Time

The device becomes active as soon as it is connected to a power source. It

has no On or Off switch. The device at first momentarily shows the software

version number, followed by reset

RST

, and then proceeds to the Run Mode.

For first-time users: Refer to the QuickStart Manual for basic operation

and set-up instructions.

If you have the Serial Communications/Ethernet Option you can easily

configure the controller on your computer or on-line.

Table 3.1 Button Function in Configuration Mode

• To enter the Menu, the user must first press

button.

• Use this button to advance/navigate to the next menu item. The user can navigate

through all the top level menus by pressing

• While a parameter is being modified, press

to escape without saving the parameter.

• Press the up

button to scroll through “flashing” selections. When a numerical value is

displayed press this key to increase value of a parameter that is currently being modified.

• Holding the

button down for approximately 3 seconds will speed up the rate at which

the set point value increments.

• In the Run Mode press

causes the display to flash the PEAK value – press again to

return to the Run Mode.

• Press the down

button to go back to a previous Top Level Menu item.

• Press this button twice to reset the controller to the Run Mode.

• When a numerical value is flashing (except set point value) press

to scroll digits from

left to right allowing the user to select the desired digit to modify.

• When a setpoint value is displayed press

to decrease value of a setpoint that is

currently being modified. Holding the

button down for approximately 3 seconds will

speed up the rate at which the setpoint value is decremented.

• In the Run Mode press c causes the display to flash the VALLEY value – press again to

return to the Run Mode.

• Press the enter d button to access the submenus from a Top Level Menu item.

• Press d to store a submenu selection or after entering a value — the display will flash a

STRD

message to confirm your selection.

• To reset flashing Peak or Valley press d.

• In the Run Mode, press d twice to enable Standby Mode with flashing

STBY

Reset: Except for Alarms, modifying any settings of the menu configuration

will reset the instrument prior to resuming Run Mode.

(UP)

(DOWN)

ENTER

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 71 72

Kommentare zu diesen Handbüchern

Keine Kommentare

Omega CNI16 Bedienungsanleitung Seite 18

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Thermometer Omega CNI16