Omega CNI16 Bedienungsanleitung PDF herunterladen (Seite 50)

SOAK ENABLE/DISABLE SUBMENU:

Press

7) Display flashes

ENBL

DSBL

Press

8) Scroll through the available selections: “Enable” or “Disable”.

Press

9) Display shows

STRD

stored message momentarily and then

advances to “Ramp Value” Submenu.

Ramp & Soak provides users with the flexibility to slowly bring the Process

Variable (PV) to the desired setpoint. Ramp & Soak values are specified in

HH.MM format. The Ramp value indicates the time specified to bring the

process variable to Setpoint 1 (SP1). Once the set point is reached, the PID

takes over and the Process Variable will be controlled at the desired set point

indefinitely. If Soak is enabled, PID will control the Process Variable at the

specified Setpoint for the duration of Soak time and then will turn off Output 1.

To start a new Ramp/Soak cycle, reset the instrument by pressing

and then

button.

An active Ramp/Soak will change SP1 one degree above the PV and will cause

the most significant digit to blink. The SP1 will be incremented by one degree

until it reaches the original SP1. The minimum Ramp time must be at least twice

the time that it will take the PV to reach the Setpoint Value (SV) with OUT 1 fully

ON.

RAMP VALUE SUBMENU:

Press

10) Display flashes 1

digit of previous stored “Ramp Value”.

Press

11) Press

and

buttons to enter a new “Ramp Value”.

Press

12) Display shows

STRD

stored message momentarily and then

advances to “Soak Value” Submenu.

SOAK VALUE SUBMENU:

Press

13) Display flashes 1

digit of previous stored “Soak Value”.

Press

14) Press

and

buttons to enter a new “Soak Value”.

Press

15) Display shows

STRD

stored message and advances to the

ID Code Menu.

The Ramp and Soak time is 00:00 to 99:59 i.e. HH.MM. (from zero to 99 hours

and 59 minutes) During Ramp & Soak do not perform any operations or settings

before first stopping it. Any alarms or other output are disabled during this time.

To stop Ramp & Soak first put instrument into Standby Mode, then go to Ramp &

Soak Menu and disable it.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 71 72

Kommentare zu diesen Handbüchern

Keine Kommentare

Omega CNI16 Bedienungsanleitung Seite 50

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Thermometer Omega CNI16